OROLUX 210 ACRYLIC MULTIPURPOSE PRIMER
Waterborne acrylic primer base for tinting systems. Excellent adhesion to many properly prepared surfaces (iron, aluminum, galvanized, plaster, wood, polyester ...). Fast drying. Over coated with a wide variety of finishes.
Viscosity (Brookfield sp6 10rpm): 2500 – 5000 cpoise
Specific gravity: 1,20 – 1,35 g/mL
Solids content: 55 – 60%
VOC: <140 g/L Directive 2004/42/CE: Limit value (2010) for this product (sub. cat. A/i): 140 g/L
Colour: White, Grey
Spreading rate: 11 – 14 m2/L (90 – 120 g/m2)
In-can appearance: Viscous liquid
Dry film appearance: Matt film, good adhesion and soft odour
Stability (withoout openning the can): 12 months at 10 – 25ºC
Gloss: 2 – 6%
Adhesion: 100% (Max: GT0)
Refining degree: ≤30 μm
Product use information
Surface: Iron, Aluminum, Galvanized, Copper, Wood, Plaster, PVC, Polyester, Cement
Surface preparation: As a general rule, the surfaces to be painted must be clean and dry. In the case of iron surfaces, if necessary, deoxidize and degrease. For other metals, degrease and sand shine. Gypsum and porous wood surfaces must be clean and dry. If necessary, sand the wood. If it is going to be applied on plastic, sand and degrease the surface previously.
Product preparation: Do not paint below 5ºC, nor at more than 80% relative humidity. Before applying, homogenize the product well with a spatula.
Application method: Brush, Roller, Pneumatic gun, Airless gun.
Dilution: Application with brush / roller: It is not diluted Application by spray: Up to 10% water
Application: 1-2 dry 30-40 μm hands
Drying: Dry touch: 1 hour
The drying time is greatly influenced by the grammage, the type and condition of the support and the environmental conditions.
Recoatable: 24 hours